Complete Toyota/Ford/Dodge Dual Remote Engine Oil 1 Micron Bypass Filter Kit~XG8A + Filters

Brand New Premium Quality State-of-the-Art Dual Remote Engine Oil Bypass Ultra Synthetic Filter Conversion Kit 
Uses Commonly Available Fully Synthetic Media High Performance Filters Costing About /set! 

Filters Included!!! 

The Filters are Both High Efficiency and High Capacity Because They Do Not Use Cellulose for Filtration. 
Perfect for TURBO Bearing Protection! 

Item Description and Usability:
· For Toyota, Old Ford, Old Dodge and Any Cars or Light Trucks using 3/4"-16 Spin-On Engine Oil filters. 
· Extends the life of your engine; increases oil flow over stock filter; increased filtration capacity; improves fuel economy up to 5% using 100% Synthetic Motor Oil Like Shell Rotella 5W40 or Castrol 5W30 Edge! 
 · Spin-on adapter replaces the FRAM PH: 4967, 4386, 3639, 3614, 2951, 2825, 43, 16 & 8A etc. filter. 
 · Adds about 2.5 quarts of oil to your system. 
Engine runs cooler and lasts longer because all abrasive particulate is filtered out using this system down to 1 micron. The larger filter by-passes the FRAM XG8A Full Flow Filter on a partial-flow basis (flowing about about 25% of the oil going to your engine) and provides maximum filtration protection against wear and oil degradation and traps the extremely small, wear-causing contaminants that full-flow filters can not remove. The bypass filter typically filters all of the oil in the system several times an hour, so the engine continuously receives analytically clean oil. Change Oil once per year or 15,000 miles whichever comes first! The XG8A filter is about at Walmart; the bypass filter is from us delivered Priority Mail in the USA. 

Includes: 
· Dual Remote Mount with ½” NPT ports 
· ¾”-16 Spin-on adapter with 3/8" NPT ports 
· 8 feet (Two 4' pre-cut Lenghts) of Premium Quality 1/2" ID 300 PSI Working Pressure (1,000 PSI Burst Strength) double-braided (3.5" bend radius) MADE IN USA HOSE (the last picture)                                     
· Four ½” ID HB Brass Fittings
· Four ½” Hose Clamps 
· Two ½" NPT Hex Port Plugs 
· 2 ¾” O-ring 
· One 3/4”-16 nipple 
· One 20mm X 3/4"-16 nipple 
· One FRAM XG8A Full Flow Filter 
· One 1 micron nominal; 3 micron (99% absolute) by-pass filter 
· Simple and Easy to Install 1 page instruction sheet, Some assembly required; you will need thread sealing compound when assembling fittings and plugs.

Further Notes: 
Also available in other versions for vehicles using oil filter thread 18mm-1.5, 20mm-1.5, 22mm-1.5, 13/16"-16, 1"-12 (Please send note at time of payment, or default is ¾”-16)